Roseman Engineering Ltd. FG3E 사용자 설명서
Fleet Gate Installation Guide Roseman Engineering Ltd
27
The Fueling Division of Roseman Engineering Ltd.
9. Preparation and Programming
9.1 Preparation Steps
Note
Make sure that the WAF is connected to the laptop or PC
otherwise when opening the software it will not open and
terminate.
otherwise when opening the software it will not open and
terminate.
1. Connect the USB cable from the programmer tool to your laptop (Refer to Figure10).
2. Run the Fleet Journal Application software from your laptop (Refer to page 31).
3. Use the Technician SVID Activation device and place it near the Fuel Inlet Antenna
– FIA
(Refer to Figure11).
You can use the activator only while the Fleet Journal Application is ON
4. Press and Hold the SVID green activation button and verify that the red led is blinking
(The red led will blink approximately 5 seconds). When the red led will appear solid
meaning that SVID activation is completed successfully. The SVID Serial Number has
been transmitted to the Fleet Journal Application software.
meaning that SVID activation is completed successfully. The SVID Serial Number has
been transmitted to the Fleet Journal Application software.
SVID activation button
Figure 11: Technician SVID Activation Device
Figure 11: FJ3 Programmer
Indication
LED
LED
USB to Laptop
FIA