HID Global Corporation 4045 사용자 설명서
ENTRYPROX – 4045-907 REV A
26
PROGRAMMING ENTRYPROX
YOU MUST KEEP A USER LIST
when programming
cards and PIN codes into your EntryProx. Write down the
User Location, Card Number, PIN Code and the Name of
the User. Use the blank form at the end of this book as a
photocopy master. You will need this information if you
need to delete a card or PIN at a later time.
User Location, Card Number, PIN Code and the Name of
the User. Use the blank form at the end of this book as a
photocopy master. You will need this information if you
need to delete a card or PIN at a later time.
DO NOT PROGRAM A CARD OR PIN IN USER
LOCATION 1
LOCATION 1
for normal access control use! User Location
1 is reserved for the MASTER CODE, which places the unit
into programming mode.
into programming mode.
CHANGE THE MASTER CODE
from the factory
default, after initial programming, and write this code down
and keep it in a safe place.
and keep it in a safe place.
IF YOU LOSE OR FORGET THE MASTER CODE
:
End Users: contact your dealer –a service call is required.
Dealers: call HID for the procedure – and remember to bring
the proper hex key or security tool to the customer site!
Dealers: call HID for the procedure – and remember to bring
the proper hex key or security tool to the customer site!
PROGRAMMING COMMAND SEQUENCES
Command sequences are simply a series of keypad entries to
add cards and PINs or change operating characteristics of the
EntryProx unit. There are three basic steps to programming
EntryProx, using the Keypad on the control unit:
add cards and PINs or change operating characteristics of the
EntryProx unit. There are three basic steps to programming
EntryProx, using the Keypad on the control unit:
1-Place the unit in programming mode
press
99 # Master Code *
2- Enter a Command Sequence
press a 2-digit command number to enter
cards/PINs or specify parameters by pressing
keys in various sequences
cards/PINs or specify parameters by pressing
keys in various sequences
3- Exit programming mode - press * to exit.
IMPORTANT – READ BEFORE
PROGRAMMING THE ENTRYPROX UNIT