HID Global Corporation 4045 Benutzerhandbuch

 

ENTRYPROX – 4045-907  REV A 

26 

 

 when programming 

cards and PIN codes into your EntryProx.  Write down the 
User Location, Card Number, PIN Code and the Name of 
the User.  Use the blank form at the end of this book as a 
photocopy master.  You will need this information if you 
need to delete a card or PIN at a later time. 

DO NOT PROGRAM A CARD OR PIN IN USER 
LOCATION 1 

for normal access control use!  User Location 

1 is reserved for the MASTER CODE, which places the unit 
into programming mode. 

 from the factory 

default, after initial programming, and write this code down 
and keep it in a safe place.   

 

End Users: contact your dealer –a service call is required.  
Dealers: call HID for the procedure – and remember to bring 
the proper hex key or security tool to the customer site! 
 

Command sequences are simply a series of keypad entries to 
add cards and PINs or change operating characteristics of the 
EntryProx unit.  There are three basic steps to programming 
EntryProx, using the Keypad on the control unit: 
 

 

press

 99 # Master Code *

 

press a 2-digit command number to enter 
cards/PINs or specify parameters by pressing 
keys in various sequences  

3- Exit programming mode - press * to exit.