Yaesu Musen Co. Ltd. 20251X50 사용자 설명서
FT-2000
Operating Manual
Vertex Standard Co., Ltd.
38
2. Rotation of the [SUB VFO-B] knob will allow you to modify your initial offset on
the fly. Offsets of up to ±9.990 kHz may be set using the Clarifier.
To cancel the Clarifier operation, press the [RX CLAR] button. The “RX” notation will
disappear from the display.
Advice: Turning the Clarifier Off simply cancels the application of the programmed
offset from the receive and/or transmit frequencies. To clear out the programmed
Clarifier offset altogether, and reset it to “zero,” press the [CLEAR] button. The
programmed offset is displayed in the small multi-channel window of the frequency
display.
TXCLAR
Without changing the receive frequency, you may alternatively apply the Clarifier
offset to the transmit frequency (typically, for “split” DX pile-ups). See page xx for
details.
Quick Point
The Tuning Offset Indicator provides a graphical representation of the Clarifier offset.
On CW, the Tuning Offset Indicator is used for CW Center Tuning, instead of Clarifier
Offset, as the transceiver is configured at the factory. If you wish to change this, so that
the Clarifier Offset is also displayed on CW, use the following procedure:
1. Press the [MENU] button to enter the Menu mode.
2. Rotate the Main Tuning Dial knob to select Menu item “010 diSP BAR SEL.
3. Rotate the [SUB VFO-B] knob to select “CLAr (Clarifier)” (replacing the default
disappear from the display.
Advice: Turning the Clarifier Off simply cancels the application of the programmed
offset from the receive and/or transmit frequencies. To clear out the programmed
Clarifier offset altogether, and reset it to “zero,” press the [CLEAR] button. The
programmed offset is displayed in the small multi-channel window of the frequency
display.
TXCLAR
Without changing the receive frequency, you may alternatively apply the Clarifier
offset to the transmit frequency (typically, for “split” DX pile-ups). See page xx for
details.
Quick Point
The Tuning Offset Indicator provides a graphical representation of the Clarifier offset.
On CW, the Tuning Offset Indicator is used for CW Center Tuning, instead of Clarifier
Offset, as the transceiver is configured at the factory. If you wish to change this, so that
the Clarifier Offset is also displayed on CW, use the following procedure:
1. Press the [MENU] button to enter the Menu mode.
2. Rotate the Main Tuning Dial knob to select Menu item “010 diSP BAR SEL.
3. Rotate the [SUB VFO-B] knob to select “CLAr (Clarifier)” (replacing the default
“C-tn (CW TUNING)” selection).
4. Press and hold in the [MENU] button for two seconds to save the new setting and
exit to normal operation.
LOCK
You may lock the setting of the Main Tuning Dial knob, to prevent accidental frequency
change.
To lock out the Main Tuning Dial knob, just press the [LOCK] button that is located to
the right of the Dial. To unlock the Dial setting, and restore normal tuning, just press
the [LOCK] button once more.