Digital Security Controls Ltd. 02RF5501433 사용자 설명서

9

5. The device is now enrolled on the system. Record the serial number and the assigned

zone number in the programming worksheets in the back of this manual.

6. Continue with steps 3 - 5 until you have enrolled all wireless devices.

7. To exit press [#].

NOTE: The devices will not work properly until you complete zone and partition pro-
gramming (see section 4).

An electronic serial number (ESN) is printed on the back of each wireless key. ESNs are
used to enroll the wireless keys with the PC5102-433 receiver.

In order to reduce the occurrence of wireless keys with the same serial number, 6-digit
serial numbers are now printed on the back of each wireless key. The 6-digit serial numbers
include hexadecimal digits. For instructions on programming hexadecimal numbers, see
your system 

Installation Manual, Section 4: How to Program.

NOTE: 6-digit serial numbers are only supported on the following control panels: PC5020, P-
8+, PC501X v2.0 & higher, P832/DL v2.0 and higher, PC1555(MX), P-6B(MX), PC580 and P-
48.

The (P)WLS909-433 and (P)WLS919-433 keys have both a 5-digit and a 6-digit serial number
printed on them. When connecting the PC5102-433 to a PC5010 v1.x or P-832 v1.x panel,
enter 5-digit serial numbers only. When connecting the PC5102-433 to a PC5020, P-8+,
PC5015 v2.x and higher, P832DL v2.x and higher, PC5010 v2.0 and higher, P832 v2.0 and
higher, PC1555(MX), P-6B(MX), PC580 or P-48 panel enter the 6-digit serial number.

For wireless keys to work on the system, you need to enroll them and then program the
function buttons, if the default values are not the functions desired. Wireless keys are not
assigned to zones and require no zone programming. You can enroll up to 8 wireless keys
on the system.

1. At a system keypad, enter [

✱][8][Installer’s Code] to go to the installer’s

programming section.

2. Enter programming section [804].

3. Enter a 2-digit number [41]-[48] to program the wireless key serial number. These

numbers correspond to wireless key numbers 01- 08.

4. Enter the key’s ESN. The entry 

must be six digits. If an older key with a 5-digit

ESN is being enrolled, add the digit [0] to the beginning of the ESN (e.g.,
ESN=61234, enter 061234).

5. The key is now enrolled on the system. Record the serial number and the assigned slot

number in the programming worksheets in the back of this manual.

6. Repeat steps 3 - 5 until all wireless keys have been enrolled.

7. (((((PC5020/P-8+/

PC5020/P-8+/

PC5020/P-8+/

PC5020/P-8+/

PC5020/P-8+/PC501

PC501

PC501

PC501

PC501X/P832/P832DL 

X/P832/P832DL 

X/P832/P832DL 

X/P832/P832DL 

X/P832/P832DL  only)

only)

only)

only)

only) By default, all wireless keys are

assigned to Partition 1. To assign keys to Partition 2, enable the appropriate options
in programming section [91].

NOTE

NOTE

NOTE

NOTE

NOTE: A wireless key can only be assigned to one partition.

8. To exit press [#].