Digital Security Controls Ltd. 06PC5132 사용자 설명서

9

3. Enter section [93]. Enter the 2-digit number of the RF Jam Detect zone ([01]

to [32]) in the programming section.

4. Disable supervision for the RF Jam detect zone by turning the relevant option off in

section [82], [83], [84] or [85]. (See section 4.3 for more information.)

5. RF jamming detection is now enabled. To exit Installer programming, press [#].

NOTE: For UL Listed installations, the RF Jam feature must be enabled - Section
[804], subsection [90], Option [7] OFF.

Returning the RF5132-433 programming to factory default settings is a quick way to
remove all the enrolled devices from the system and reset all the programming in
section [804].

NOTE: Performing this procedure will not change any programming sections except
[804]. Resetting the control panel to factory default settings will not return the RF5132-
433 module to factory default settings.

To restore the RF5132-433 programming to the factory default settings:
1. Enter [*][8] [Installer’s Code].
2. Enter programming section [996].
3. Enter the Installer’s Code, followed by [996] again. The software for the

RF5132-433 will be restored to its factory default settings.

4. To continue programming the unit, exit installer’s programming by pressing

[#] and then re-enter installer’s programming by entering [*][8] [Installer’s
Code].

For instructions on restoring the default programming of the control panel or any
other connected module, see your system 

Installation Manual.

To remove a wireless device from the system, follow the guideline for enrolling a
wireless device (see section 3.2). Program the ESN as [000000]. The wireless device
for the zone will be removed.

NOTE: You may need to remove power from the panel in order to clear troubles
caused by deleted zones.

Now that you have completed all RF5132-433 related programming, you can test and
mount the receiver and devices. See section 5 for more information.