Справочник Пользователя для Digital Security Controls Ltd. 06PC5132
9
O T H E R P R O G R A M M I N G
3. Enter section [93]. Enter the 2-digit number of the RF Jam Detect zone ([01]
to [32]) in the programming section.
4. Disable supervision for the RF Jam detect zone by turning the relevant option off in
section [82], [83], [84] or [85]. (See section 4.3 for more information.)
5. RF jamming detection is now enabled. To exit Installer programming, press [#].
NOTE: For UL Listed installations, the RF Jam feature must be enabled - Section
[804], subsection [90], Option [7] OFF.
[804], subsection [90], Option [7] OFF.
4.5 RF5132-433 Software Default
Returning the RF5132-433 programming to factory default settings is a quick way to
remove all the enrolled devices from the system and reset all the programming in
section [804].
remove all the enrolled devices from the system and reset all the programming in
section [804].
NOTE: Performing this procedure will not change any programming sections except
[804]. Resetting the control panel to factory default settings will not return the RF5132-
433 module to factory default settings.
[804]. Resetting the control panel to factory default settings will not return the RF5132-
433 module to factory default settings.
To restore the RF5132-433 programming to the factory default settings:
1. Enter [*][8] [Installer’s Code].
2. Enter programming section [996].
3. Enter the Installer’s Code, followed by [996] again. The software for the
1. Enter [*][8] [Installer’s Code].
2. Enter programming section [996].
3. Enter the Installer’s Code, followed by [996] again. The software for the
RF5132-433 will be restored to its factory default settings.
4. To continue programming the unit, exit installer’s programming by pressing
[#] and then re-enter installer’s programming by entering [*][8] [Installer’s
Code].
Code].
For instructions on restoring the default programming of the control panel or any
other connected module, see your system
other connected module, see your system
Installation Manual.
4.6 Deleting Wireless Devices
To remove a wireless device from the system, follow the guideline for enrolling a
wireless device (see section 3.2). Program the ESN as [000000]. The wireless device
for the zone will be removed.
wireless device (see section 3.2). Program the ESN as [000000]. The wireless device
for the zone will be removed.
NOTE: You may need to remove power from the panel in order to clear troubles
caused by deleted zones.
caused by deleted zones.
Now that you have completed all RF5132-433 related programming, you can test and
mount the receiver and devices. See section 5 for more information.
mount the receiver and devices. See section 5 for more information.