TransCore 05531 사용자 설명서
Configuring the Encompass 4/4800 Multiprotocol Reader
8-11
To verify tag read capability
1.
Once communications are verified as described in “Verifying Communications"
on page 8-8, enter the following sequence of commands to turn on continuous
RF:
on page 8-8, enter the following sequence of commands to turn on continuous
RF:
•
#0121
•
#6401
•
#470
•
#00
2.
Pass one test tag in front of the unit. If the Encompass 4/4800 Multiprotocol
Reader reads the tag, the terminal emulation application displays the tag
information on the screen as shown in
Reader reads the tag, the terminal emulation application displays the tag
information on the screen as shown in
Figure 8-6 Successful Tag Read
If the tag ID is not displayed, perform the following actions:
•
Verify that the Encompass 4/4800 Multiprotocol Reader is in data
mode (command #00 Switch to Data Mode).
mode (command #00 Switch to Data Mode).
•
Ensure that the tag you are using is compatible with the
Encompass 4/4800 Multiprotocol Reader. The Encompass 4/4800
Multiprotocol Reader has the capability to read the eGo
Windshield Sticker Tag as well as tags compliant with ATA and
ISO standards, including TransCore’s IT2000 tags with the ATA/
ISO mode enabled.
Encompass 4/4800 Multiprotocol Reader. The Encompass 4/4800
Multiprotocol Reader has the capability to read the eGo
Windshield Sticker Tag as well as tags compliant with ATA and
ISO standards, including TransCore’s IT2000 tags with the ATA/
ISO mode enabled.
•
A full-frame Encompass 4/4800 Multiprotocol Reader displays
either half or full-frame ATA-protocol tags. If you are using half-
frame Wiegand Windshield Sticker Tags, you might not see any
tag ID information displayed.
either half or full-frame ATA-protocol tags. If you are using half-
frame Wiegand Windshield Sticker Tags, you might not see any
tag ID information displayed.
•
Using the audible circuit tester as described in
, verify that the reader is capable of
reading the tag in the read zone. If it is, the problem is probably in
the communications between the Encompass 4/4800
Multiprotocol Reader and the host.
the communications between the Encompass 4/4800
Multiprotocol Reader and the host.
Successful
Tag Read