GatesAir Inc. CZF 사용자 설명서

 

  

APEX

™

 Exciter Incorporating FLO

™

 Technology

Navigating the LCD Display Screens

Details of the Exciter Status Screens

Page: 3-28

888-2604-001

03/08/07

WARNING: Disconnect primary power prior to servicing.

• Exc Active: (Off or On) When on, this exciter is on the air.

• RF Present: (Off or On) This is an indication that the RF level at the output of the ex-

citer is above a given threshold level. The RF presence threshold is an RF output level 
of approximately 5 mW.

• Board Type: (UHF or VHF) Interface configured to fit existing UHF and VHF exciter 

interface connections.

• Board Rev: This is the board revision for the External I/O board.

• CPLD Rev: This is the software revision level of the CPLD in the External I/O board.

• EEPROM: (Ok or FAULT) The EEPROM is the local board memory. It stores board 

specific information such as board type, board revision, CPLD revision, and other lo-
cal data.

Within any of these screens, touching Home returns to the main
screen, and touching Fault brings up the Exciter Status screen.

ExternalIODiagnostics.bmp

The External I/O Diagnostics screen is shown in Figure 3-26. 

Analog loopback: Choices are Enabled or Disabled. Disabled is the normal setting. 

• This function loops an analog output back through an analog input channel for diag-

nostics purposes.

The last two screen entries are Analog Output A and Analog Output B. These two entries
provide a voltage for the analog loopback test mentioned above.

• Analog Output A is looped back through analog Analog 1 and 3 inputs and Analog 

Output B is looped back through Analog 2 and 4 inputs, see external I/O Board screen 
Figure 3-25 for the analog inputs.