HARRIS CORPORATION M7200VTAC 사용자 설명서
MM-011553-001
2. Enter the number of the destination radio (e.g., 027-001-0006) using the DTMF keypad. If the region
number (first 3 digits; 027 in this example) is the same as this radio’s region number, these digits do
not need to be entered. Likewise, if the region and agency numbers (first 6 digits; 027-001 in this
example) are the same as this radio’s numbers, these digits do not need to be entered. Leading zeros
can also be ignored. Refer to Section 6.13.
not need to be entered. Likewise, if the region and agency numbers (first 6 digits; 027-001 in this
example) are the same as this radio’s numbers, these digits do not need to be entered. Leading zeros
can also be ignored. Refer to Section 6.13.
3. Press the # key to enter the number.
Choosing and Sending the Message
After specifying the destination radio’s User ID (Section 6.27.1), the radio automatically allows you to
choose a message. The current message scrolls across the top line of the display. To choose a message:
choose a message. The current message scrolls across the top line of the display. To choose a message:
1. Scroll through the message list using
. The next available message in the list is displayed.
Pause between each arrow button depress to observe the entire message as it scrolls across the top line
of the display.
of the display.
2. To select and send the displayed message, press the Select button, or press the # button on the
keypad.
3. The status of the sent message will be momentarily displayed (Table 6-7).
Table 6-7: Status of Selective Alert
STATUS MESSAGE
DEFINITION
Delivering
Select Alert message transmit attempt
Busy
Too busy – Try again
Dest Down
Receiving radio not logged on – Not registered
Not Reg
Transmitting radio not logged on – Not registered
Delivered Transmission
complete
Unreachable No
response
Partial Transmission
interrupted
6.27.2 Receiving
Messages
When a selective alert message is received by a radio, a four-beep tone is heard and “NewAlert” flashes
until the new message is read. Up to eight (8) received messages are stored. If another message is
received, the first (oldest) message is automatically deleted to make room for new incoming messages.
until the new message is read. Up to eight (8) received messages are stored. If another message is
received, the first (oldest) message is automatically deleted to make room for new incoming messages.
Displaying Received Messages
1. Using
, scroll through the menu until “AlertsRecvd” (Alerts Received) appears in the bottom
line of the display. “No alerts” or the last received (newest) message appears in the display. It is
preceded by the time the message was received, and the sender’s name/alias.
preceded by the time the message was received, and the sender’s name/alias.
2. View other received messages using
.
3. To delete the message currently being viewed, press the
MENU
button.
Deleting Received Messages
To delete a received message:
1. Display the message.
32