HARRIS CORPORATION M7200VTAC 사용자 설명서

2.  Using 

, scroll through the pre-programmed speed-dial numbers until the desired number 

appears in the display. 

3.  Press and release the PTT button to ring the other user. 

a.  The ring tone is sounded. 

b.  If the other user accepts the call, the called user’s alias will appear in initiating caller’s display. 

The two are now in a private call until one ends the call, the call is terminated due to an initiated 
emergency, or the maximum time limit of ten (10) minutes is reached. 

4.  To end the call, press the 

 button. 

When someone calls in from another radio using the selective call function, a ring will sound in the 
speaker and/or headset. Use the + ramp control to answer the call and press the microphone’s PTT button 
when speaking (transmitting) to the caller. Press the 

 button to end the call. 

A selective call will be interrupted if an emergency is declared on a monitored talk group. 

Selective alert messaging is an OTP feature allowing one of up to eight (8) pre-programmed text 
messages (refer to Section 6.27.3) to be sent from one radio to another. The user specifies a destination 
radio’s User ID, selects one of the pre-programmed text messages, and then transmits it to the destination 
radio. The message delivery system adds time-of-day information and forwards the message to the 
destination (receiving) radio. The sending radio receives a brief message noting the status of the 
transmission. Refer to Table 6-7 for a list of possible status messages. 

The first few characters of a message are part of the message text entered when the message is 
programmed. This programming is performed by the system or network administration personnel. 

Messages successfully received by the destination radio are stored in it until read or until it is power 
cycled. 

The destination radio’s User ID can be selected via the menu or via the keypad on the system model 
control head. 

1.  Using 

, scroll through the menu until “AlertDest” (Alert Destination) appears in the bottom 

line of the display. The current speed dial number scrolls on the top line. 

2.  Use 

 to change to a different speed-dial number.  

3.  When the desired speed-dial number appears, press the 

 button to activate the selection. 

4.  Choose and send the message. 

To select the destination radio’s User ID using the keypad, perform the following: 

1.  Press *7 on the keypad. “AlertDest” appears in the display.