PRÜFTECHNIK Condition Monitoring GmbH VCRFBR24 사용자 설명서
43
VIBCONNECT RF 05.2012
• After completion of the field strength measurement, remove the
short-circuit bridges and the voltmeter.
• If you do not intend to commission the sensor unit at that point
in time, remove one of the batteries to save energy.
Note
Maintaining battery charge
Until the sensor unit has received a valid measuring configuration
from the bridge, it continuously sends out requests, using battery
power.
Until the sensor unit has received a valid measuring configuration
from the bridge, it continuously sends out requests, using battery
power.
» If you wish to program the measuring configuration at a later
stage, switch off battery-powered sensor units by removing
one battery.
one battery.
Note
IC (Industry Canada)
Under Industry Canada regulations, the sensor unit may only
operate using an antenna of a type and maximum (or lesser)
gain approved for the sensor unit by Industry Canada. To reduce
potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically radi-
ated power (e.i.r.p.) is not more than that necessary for successful
communication.
Under Industry Canada regulations, the sensor unit may only
operate using an antenna of a type and maximum (or lesser)
gain approved for the sensor unit by Industry Canada. To reduce
potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically radi-
ated power (e.i.r.p.) is not more than that necessary for successful
communication.
Installation and commissioning