Vertical Communications 7500-00 사용자 설명서
Assembling the IP Phone
2-5
Chapter 2 - Install & Connect the Phone
Xcelerator IP User Guide
March 2007
Connecting the Handset
Use the curled cord (1) to connect to the phone jack (3) at the bottom of the handset (2),
as shown in the following illustration. Plug the other end of curled cord to the Handset
jack (5) on the side of IP phone. The other RJ-9 jack (4) is for a headset. This completes
the assembly of the IP phone.
Setting the PoE or PA Power Source Switch
Before connecting the cables, set the power source switch to the correct position. It is
located to the right of the I/O ports on the back, as shown in the following illustration.
Use a pen to set it to one of the following:
Use a pen to set it to one of the following:
Adaptor position - Use this position if you are using an external standard power
adaptor.
PoE position - Use this position if you can offer Power over Ethernet (PoE,
PoE position - Use this position if you can offer Power over Ethernet (PoE,
IEEE802.3af compliant) to the phone.
The Power source switch default setting is "Adaptor".
The Power source switch default setting is "Adaptor".