Uniden America Corporation UB315 사용자 설명서
different ways. You will find that Search, Hold, Lockout and
Scan, Delay are all similar to conventional scanning.
Scan, Delay are all similar to conventional scanning.
❖
TRUNKED SEARCH lets you hear all system talkgroup
activity (unit-to-unit I-Calls may be received as well).
This is the best way to get started.
activity (unit-to-unit I-Calls may be received as well).
This is the best way to get started.
❖
ID SEARCH HOLD works with Search mode to let you
quickly freeze reception on an interesting transmission.
Or you can manually specify a talkgroup with DIRECT
ENTRY in ID HOLD.
quickly freeze reception on an interesting transmission.
Or you can manually specify a talkgroup with DIRECT
ENTRY in ID HOLD.
❖
ID LOCKOUT works with Search and Scan to exclude
talkgroups that you don't want to hear.
talkgroups that you don't want to hear.
❖
ID SCAN lets you receive those talkgroups that you
store in Scan Lists.
store in Scan Lists.
❖
ID SCAN HOLD lets you selectively listen to a
talkgroup in your Scan Lists.
talkgroup in your Scan Lists.
❖
ID DELAY works with each talkgroup to be delayed for
5 seconds when the communication ends.
5 seconds when the communication ends.
When receiving EDACS systems, remember that Uniden's
AFS talkgroups give you powerful flexibility. In a few key
presses, you can specify a single talkgroup, a fleet, or an
entire agency in all the above modes. Read the section
"EDACS Reception" to understand how this works.
AFS talkgroups give you powerful flexibility. In a few key
presses, you can specify a single talkgroup, a fleet, or an
entire agency in all the above modes. Read the section
"EDACS Reception" to understand how this works.
Note: To switch ID SCAN or ID SEARCH, press and hold
TRUNK in the trunked system.
Trunked Search
Once you have programmed all the frequencies for a trunked
system, SEARCH will let you immediately start hearing
transmissions. It is suggested you try SEARCH mode first.
system, SEARCH will let you immediately start hearing
transmissions. It is suggested you try SEARCH mode first.
1. Press SCAN, and select the bank(s) you wish to receive,
just as you select banks in conventional scanning.
2. Press TRUNK to enable trunked reception. The radio will
seek and acquire the trunked system control channel. The
scanner will now be in MONITOR mode. You will hear the
control channel and see active talkgroups on the display.
You will not hear the voice transmissions in MONITOR
mode.
scanner will now be in MONITOR mode. You will hear the
control channel and see active talkgroups on the display.
You will not hear the voice transmissions in MONITOR
mode.
☞
Hint: MONITOR mode is an excellent way to observe
system activity and determine which talkgroups are
most active. Locked out IDs display during MONITOR
mode.
most active. Locked out IDs display during MONITOR
mode.
3. Press SEARCH to begin searching and receiving. You will
hear talkgroups and see them on the display.
52
BC250D 9/20/2 2:52 PM Page 52