Enlighted Inc. WS100 사용자 설명서
M OU NTING
PA RTS IN C LU DE D
+
Enlighted Room Control
+
One gang wallplate with hidden
mounting screws hardware
+
2x construction screws
+
2x spacers
TO O L S N EED ED
+
Screwdriver
+
Level
D I M E N S I O N S
32mm L x 65mm W x 4mm H
INSTRUCTIONS
1.
Align the backplate with the Room Control with arrow pointing up. Affix to
the Room Control by firmly tightening both screws.
the Room Control by firmly tightening both screws.
2.
Align spacers to the Room Control. Place spacers against the back of the
switch—one at the top and one at the bottom—and align the spacers with
the oval screw hole of the mounting plate. Ensure flush side of the spacers
face the wall. Hold in place against desired wall location.
switch—one at the top and one at the bottom—and align the spacers with
the oval screw hole of the mounting plate. Ensure flush side of the spacers
face the wall. Hold in place against desired wall location.
3.
Screw on backplate using construction screws provided.
4. Snap on wallplate with arrow pointing up.
TE CH N ICA L S P E CI FIC ATIO N S
Action
Four push buttons; six software-configurable scenes
Actuations
50,000 rated
Power
Battery-powered: CR 2025
Battery Life
5 years approximate
Max Fixtures Per Switch
100
Security
AES-128 Encryption
Interoperability
Enlighted Gen2 Sensors and Gateways
Radio Frequency
2.4 GHz ISM Band
RF TX Output Power
0 dBm
Wireless Protocol
IEEE 802.15.4
Wireless Range
300 feet line-of-sight
Operating Environment
0 to 50° C / 32 to 120° F
Enclosure
Polycarbonate
CO M P LIA N CE
Wo rl dwid e
RoHS, IC
United States
FCC Class A Part 15, UL Listed
FCC ID: AQQ-WS100; IC: 10138A-WS100
Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by Enlighted Inc. could void the user’s authority to operate the equipment.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée
aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
930 Benecia Avenue, Sunnyvale CA 94085 | P: 650.964.1094
© Copyright 2013. All Rights Reserved.
2