Enlighted Inc. WS100 Manual Do Utilizador

M OU NTING

PA RTS IN C LU DE D

Enlighted Room Control

One gang wallplate with hidden

mounting screws hardware

2x construction screws

2x spacers

TO O L S N EED ED

Screwdriver

Level

D I M E N S I O N S

32mm L x 65mm W x 4mm H

INSTRUCTIONS

Align the backplate with the Room Control with arrow pointing up. Affix to
the Room Control by firmly tightening both screws.

Align  spacers to  the  Room Control. Place spacers against the back of the
switch—one at  the  top  and  one  at  the  bottom—and  align the spacers with
the  oval screw hole of  the mounting plate. Ensure flush side of  the spacers
face the  wall.  Hold   in  place against desired wall location.

Screw on backplate using construction screws provided.

4. Snap on wallplate with arrow pointing up.

TE CH N ICA L S P E CI FIC ATIO N S

Action

Four push buttons; six software-configurable scenes

Actuations

50,000 rated

Power

Battery-powered: CR 2025

Battery Life

5 years approximate

Max Fixtures Per Switch

100

Security

AES-128 Encryption

Interoperability

Enlighted Gen2 Sensors and Gateways

Radio Frequency

2.4 GHz ISM Band

RF TX Output Power

0 dBm

Wireless Protocol

IEEE 802.15.4

Wireless Range

300 feet line-of-sight

Operating Environment

0 to 50° C / 32 to 120° F

Enclosure

Polycarbonate

CO M P LIA N CE

Wo rl dwid e

RoHS, IC

United States

FCC Class A Part 15, UL Listed

FCC ID: AQQ-WS100; IC: 10138A-WS100

Warning:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by Enlighted Inc. could void the user’s authority to operate the equipment.

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device

may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée

aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

930 Benecia Avenue, Sunnyvale CA 94085 | P: 650.964.1094