Onkyo Corporation UTX1 사용자 설명서
13
Using the UWL-1
—Continued
With the UWL-1, you can play the digital music stored on your PC through an audio system or
powered speakers located in any room in your house. You can also stream Internet radio, CDs,
or DVDs.
powered speakers located in any room in your house. You can also stream Internet radio, CDs,
or DVDs.
1
Make sure the Transmitter is plugged into your PC properly (see page 9).
2
If the Receiver’s STANDBY indicator is on, press the [STANDBY/ON] button to
turn on the Receiver.
turn on the Receiver.
The Receiver’s SYNC indicator
will light up when it’s synchro-
nized with the Transmitter and
ready for use.
will light up when it’s synchro-
nized with the Transmitter and
ready for use.
3
Turn on the audio system or powered speakers that you’ve connected to the
Receiver (see page 10), select the input source, and turn up the volume.
Receiver (see page 10), select the input source, and turn up the volume.
4
Use Windows
®
Media Player or another audio playback program to play a dig-
ital music file, or load a CD and play that.
The audio will be transmitted wirelessly by the Transmitter to the Receiver and output via
the audio system or powered speakers that you’ve connected to the Receiver. If you don’t
hear anything, see “Troubleshooting” on page 16.
the audio system or powered speakers that you’ve connected to the Receiver. If you don’t
hear anything, see “Troubleshooting” on page 16.
5
When you’ve finished using the UWL-1, press the Receiver’s [STANDBY/ON]
button to set it to Standby.
button to set it to Standby.
The Receiver’s STANDBY indicator lights up.
6
Stop audio playback on your PC, and then unplug the Transmitter.
If it’s not practical to unplug the Transmitter every time you finish using it, you can leave it
plugged in, but to output sound from your PC’s built-in speakers, you’ll need to change the
plugged in, but to output sound from your PC’s built-in speakers, you’ll need to change the
Default device
setting on the
Audio
tab of the
Sounds and Audio Devices Properties
con-
trol panel (see page 19).
Listening to Music
Note: To listen to a CD in your PC’s CD/DVD drive, digital CD playback must be enabled
(see page 15).
(see page 15).
Note: If no audio is output by your PC for a while, the Transmitter will stop transmitting
and the Transmit indicator will go off. The next time audio is output, the Transmitter will
start transmitting again and the Transmit indicator will light up. However, it takes the Trans-
mitter a few seconds to synchronize with the Receiver, during which no audio will be heard,
so you may not hear the first few seconds of the first song you play. To prevent this, output
some audio to light up the Transmit indicator beforehand.
and the Transmit indicator will go off. The next time audio is output, the Transmitter will
start transmitting again and the Transmit indicator will light up. However, it takes the Trans-
mitter a few seconds to synchronize with the Receiver, during which no audio will be heard,
so you may not hear the first few seconds of the first song you play. To prevent this, output
some audio to light up the Transmit indicator beforehand.
STANDBY / ON
STANDBY
indicator
indicator
SYNC
indicator
indicator
UWL-1_En.book Page 13 Monday, September 11, 2006 11:13 AM