Onkyo Corporation UTX1 사용자 설명서
11
Setting Up the UWL-1
—Continued
■
Connecting an Onkyo Component with a DC Output (European Model)
The Receiver is set to the same ID as the Transmitter before it leaves the factory, so normally
you don’t need to change it. However, if you have several Receivers and want them all to
receive audio from the same Transmitter, you’ll need to set them all to the same ID.
you don’t need to change it. However, if you have several Receivers and want them all to
receive audio from the same Transmitter, you’ll need to set them all to the same ID.
1
With your PC on, plug the Transmitter into a USB port, and then connect the
AC adapter to the Receiver.
AC adapter to the Receiver.
2
Put the Receiver close to the Transmitter (30–100 cm apart).
3
Press and hold down the Receiver’s [CH SELECT] button for at least 3 sec-
onds, and then press and hold down the Transmitter’s [CH SELECT] button
for at least 6 seconds.
onds, and then press and hold down the Transmitter’s [CH SELECT] button
for at least 6 seconds.
The Transmitter’s Transmit indicator and the Receiver’s STANDBY indicator both flash,
and the Receiver detects the Transmitter’s ID. Once the Receiver has recognized the Trans-
mitter’s ID successfully, the Receiver’s SYNC indicator lights up.
and the Receiver detects the Transmitter’s ID. Once the Receiver has recognized the Trans-
mitter’s ID successfully, the Receiver’s SYNC indicator lights up.
Changing the Receiver’s ID
DIGITAL
OPTICAL
I N
DC5V
2W/0.4A MAX.
2W/0.4A MAX.
DC OUT
L
R
LINE 1
IN
Optical digital audio cable
Dedicated DC power cable*
* Use the included dedicated DC power cable only with Onkyo
components that have a DC output. Don’t use it for any other
purpose.
purpose.
Onkyo component with DC output
Receiver (RX-1)
Note: When you use the dedicated DC power cable, use the
included optical digital audio cable for the audio connection, as
the audio quality may suffer with an analog audio connection. If
you do use an analog connection, use the included AC adapter
instead of the dedicated DC power cable.
included optical digital audio cable for the audio connection, as
the audio quality may suffer with an analog audio connection. If
you do use an analog connection, use the included AC adapter
instead of the dedicated DC power cable.
Miniplug-to-RCA audio cable
Connect one or the other.
Receiver (RX-1)
CH SELECT button
STANDBY indicator
SYNC indicator
Transmitter (UTX-1)
Transmit indicator
CH SELECT button
30–100 cm apart
UWL-1_En.book Page 11 Monday, September 11, 2006 11:13 AM