Onkyo Corporation UTX1 사용자 설명서

 

9

 

Wait until the startup process is complete and Windows

 

®

 

 is ready to use.

 

The Transmitter’s Transmit indicator lights up.
Be careful to insert the Transmitter the right way.

When you plug the Transmitter into your PC for the very 
first time, Windows

 

®

 

 will automatically detect it as new 

hardware and install the necessary drivers. Please wait 
until this process is complete. If Windows

 

®

 

 does not detect 

it automatically, see below.

If Windows

 

®

 

 doesn’t install the drivers automatically, unplug the Transmitter, wait about 15 sec-

onds, then plug it in again. If it still doesn’t install them, follow the procedure below:

 

Click the 

 

 button, and then click 

 

.

 

Click 

 

, and then click 

 

.

 

Select the 

 

 tab, and then click the 

 

 button.

 

Double-click the corresponding item in the device list to open the 

 

 window.

 

Select the 

 

 tab, click the 

 

 button to open the Add Hardware Wizard, and 

follow the onscreen instructions to install the drivers.

Note: Before you plug or unplug the Transmitter, turn down the volume on your audio sys-
tem or powered speakers, or unplug the Receiver’s AC adapter from the wall outlet.

Transmit indicator

(The position and number of USB 
ports depends on your PC. Check 
your PC’s manual for details.)

Notes:
• Since the Transmitter requires a lot of power, it should be connected directly to a USB port 

on your PC. However, if your PC is located on the floor, or it’s a large tower or desktop PC 
and its USB ports are located at the rear, wireless transmission may be obstructed and audio 
playback may be interrupted. In this case, try moving the Transmitter to another location. If 
you can’t relocate your PC, using a commercially available USB extension cable and mov-
ing the Transmitter to another location may resolve the issue. If you’re using a powered USB 
hub, make sure its AC adapter is plugged in when you use the UWL-1.

• Always stop audio playback on your PC before plugging in or unplugging the Transmit-

ter. It’s OK to plug in or unplug the Transmitter while your PC is on.

• If your PC has several USB ports, you can plug the Transmitter into any port. Note that 

some PCs may detect the Transmitter as a new device if you plug it into another port. In 
this case, simply allow Windows

®

 to perform the installation again.

• Always plug the Transmitter into your PC before starting playback. If you plug it in after 

starting playback, the audio will not be transmitted.

• While the Transmitter is plugged into your PC, your PC’s built-in speakers will not output 

any sound. This is because USB audio devices have priority. To output sound from your 
PC’s built-in speakers, unplug the Transmitter, or change the Default device setting on the 
Audio tab of the Sounds and Audio Devices Properties control panel (see page 19).

UWL-1_En.book Page 9 Monday, September 11, 2006 11:13 AM