Casio Computer Co Ltd XJH1750 사용자 설명서

Operation During Projection

Turning on the projector initially causes the same input source that was selected the last time it was
turned off to be selected.

To select a different input source

Press the [INPUT] key.

z This displays the input source selection screen.

Select either the Normal Input Mode or 3D Input Mode depending on the type of
image you want to project.

z For details about the 3D Input Mode, see the explanation in the following section.

Use the [

T] and [S] keys to select the name of the input source you want to

select and then press the [ENTER] key.

z The name of the input source you select appears in the upper right corner of the projection

screen for a few seconds.

z The message “No signal input.” will appear if no input signal can be selected.

Note

The table below shows how the input source selection affects the projector’s MONITOR OUT
terminal and speaker (or AUDIO OUT terminal)

output signals.

Selecting the Input Source

When this input source is

selected:

The video input signal from this

terminal is output to the

MONITOR OUT terminal:

The audio input signal from this

terminal is output to the speaker

(or AUDIO OUT terminal):

Computer 1

COMPUTER IN 1

AUDIO IN 1

Computer 2

COMPUTER IN 2

AUDIO IN 2

S-video

*2 *3

AUDIO IN L/R

Video

*2 *3

AUDIO IN L/R

HDMI

*2 *3

HDMI

USB

*2 *3

USB

*1 Audio is output from either the speaker or AUDIO OUT terminal in accordance with the setup

menu “Option Settings 2

J Audio Output” setting.

*2 Output is proper only when the input signal is an RGB signal. Output is not guaranteed when

the input signal is a component signal.

*3 The video input signal is output from either Computer 1 or Computer 2, in accordance with

the last selected input source (COMPUTER IN 1 terminal or COMPUTER IN 2 terminal). For
example, even if the input source is switched from Computer 1 to S-video, the MONITOR
OUT terminal continues output the video input signal from COMPUTER IN 1.