Mitsubishi Electric Corp HS-U577 사용자 설명서

55

If your VCR malfunctions, try the following steps prior to contacting your Mitsubishi Dealer:

1 Check the Trouble Checks on the next page to see if there is a solution to the current problem that

you are experiencing.

2 If the problem is not addressed on the Trouble Checks page, the safety circuits in the VCR may be

in operation, thus please try the following: (the clock setting and the timer recording will be deleted.)

1 If possible, press EJECT on the front panel and remove the tape.

2 Press TIMER RESET on the rear panel with a pencil or a ball point pen.

3 If a tape is not loaded, press POWER to turn the power on.  If a tape is loaded, wait about 1

minute until the tape protecting function is completed, then press POWER.

3 You may also try the following procedure if the above steps did not resolve the problem.  (All

settings will be reset to the default settings.)

1 Press POWER on the front panel continuously for about 8 seconds until the current time display

on the front panel shows “- : - -”.

2 If a tape is not loaded, press POWER to turn the power on.  If a tape is loaded, the tape

protecting function will work and “99” will appear on the front panel display to begin count down.
Wait about 1 minute until it reaches “00” to show the tape protecting function is completed, then
press POWER.

If the problem with your VCR persists, contact your Mitsubishi dealer for assistance.

The VCR won’t turn on.

The VCR power is on but no
controls work.

You can’t see the VCR’s picture
on your TV.

Poor picture when watching the
VCR’s tuner on your TV.

VCR REC button doesn’t function.

No picture during recording.

VCR does not record TV
program.

• Check the power cord and the AC outlet.
• Is the child lock in use?  If so, press and hold DISPLAY on the remote

for more than 8 seconds until the LOC display turns off.

• Is the child lock in use?  If so, press and hold DISPLAY on the remote

for more than 8 seconds until the LOC display turns off.

• Set the VCR/TV slide switch to VCR position.
• Press TIMER RESET on the rear panel.

• Check the TV’s input setting.
• Check to see that your VCR is not set to L1 or L2.

• Check to see if your TV is set to the correct channel or input.
• Check your TV’s fine tuning, if using an older TV.
• Check your connections to make sure they are secure.

• Check the erasure prevention tab on the tape cassette.

• Check the hook-up.
• Check to see if your TV is set to the correct channel or input.

• Check the VCR tuning.
• Check the input selection on the VCR.  Does the channel display on

the TV screen show L1 or L2? If so, switch it to tuner by pressing
INPUT.