Bosch Security Systems BV NDE8000 사용자 설명서
20
en | Hardware Installation
FLEXIDOME IP starlight 8000i
2018.11 | 01 |
Installation Manual
Bosch Security Systems
The installation of the cable conduit is finished.
Preparing the camera top for on-surface cable routing
There is a lid on the camera top which has to be removed in order to have the required space
for the cable duct.
Preliminaries
A Phillips screwdriver
Steps
1.
Unfasten and remove the screw
2.
Remove the lid
Keep both parts in a safe space for later use.
4.3
Wiring
Caution!
The unit has connection terminals on flying leads. In wet or outdoor installations, use a field
wiring box with NEMA Type 4X or IP66 protection level or better. After connections are made,
ensure the watertight compartment is tightly closed and cables and conduits are properly
sealed to prevent water ingress.
Notice!
Use proper surge suppression on cables that are routed outdoors, or close to large inductive
loads or electrical mains supply cables.
4.3.1
Input/output connector
Use the 10-pin terminal for on-site cable commissioning. The terminal fits into its counterpart
on the camera base.