Bosch Security Systems BV NDE8000 사용자 설명서

FLEXIDOME IP starlight 8000i

Troubleshooting | en

Bosch Security Systems

Installation Manual

2018.11 | 01 |

Incorrect firmware file.

Enter the IP address of the unit

followed by /main.htmin your

Web browser and repeat the

upload.

Web browser contains

empty fields.

Active proxy server in network.

Create a rule in the local

computer's proxy settings to

exclude local IP addresses.

The ping command can be used to check the connection between two IP addresses. This

allows testing whether a device is active in the network.

1.

Open the DOS command prompt.

2.

Type ping followed by the IP address of the device.

If the device is found, the response appears as "Reply from ... ", followed by the number of

bytes sent and the transmission time in milliseconds. Otherwise, the device cannot be

accessed via the network. This might be because:

–

The device is not properly connected to the network. Check the cable connections in this

case.

–

The device is not correctly integrated into the network. Check the IP address, subnet

mask, and gateway address.

If a fault cannot be resolved, please contact your supplier or system integrator, or go directly

to Bosch Security Systems Customer Service.

The version numbers of the internal firmware can be viewed on a service page. Please note

this information before contacting Customer Service.

1.

In the address bar of your browser, after the unit IP address, enter: /version

for example: 192.168.0.80/version

2.

Write down the information or print out the page.