GREAT WALL TOYS 2017B 사용자 설명서

1.Remove the color package and take out the plastic box.

   Pull the button to the right as arrow 1 pointed, and get 

   the transmitter by the direction of arrow 2.(Graph 1)

6+

ages

Graph 1

Name of product：1:67 mini racing car

Product features：

PLAYING TIME：6-10 minutes(equipped with large 

capacity battery, the car can reach its best effect after 

charing and discharging several times）；

REMOTE CONTROL DISTANCE：6-20 metres；

GREAT PERFORMANCE：reliable frequency 

selection and strong anti-interference ability.

  2.Pull out the antenna as graph 

     2 shows.

3.Insert the antenna into the hole 

   at the top of the transmitter 

   and tighten it.（Graph3）

4.Open the battery cover，insert  

   3X1.5V AA battery with correct 

   polarity  and replace the battery 

   cover.(Graph4)

5.Rip off the tape， pull out

   the transparent cover.

 （

Graph5）

6.Open the lock catch.(Graph6)

7.Drag the car according to the 

   direction ，and take out the car.

（

Graph7）

Open the charging cover and pull out the charging 

plug，then insert the plug into the car’s charging 

interface hole, the indicator light will be on，

around 7 minutes later, the indicator will be off ,

which means the car is fully charged, then pull out 

the charging plug.(Graph 8)

1.Introduction of transmitter fuctions.（Graph 9）

2.Fully extend the antena when playing, turn on the power 

   switch of the racing car.

3.Press the transmitter and the indicator will be on which 

   means the racing car is ready to play. when pressing the 

   forward/backward button, the car will operate corresponding 

   action,meanwhile the car’s front/rear lamp will be on 

   according to the operation.If you want the car to turn left/right, 

   press left/right button  and  forward/backward button at the 

   same time. 

4.At the bottom  from the car’s  forepart，there is a trim 

   machine which can correct the car to run in a straight line.

   (Graph 10)

a).Do not touch the antenna during operation，or the remote control distance will be affected.

    Breaking antenna needs adults to handle.

b).Due to the  inertia and strong power of the car, it cannot stop immediately when running in 

    high speed.

c).If the car becomes apprently slow during operation, this may due to insufficient power, 

    please charge the racing car as this manual describes .

d).When the car is fully charged,please do not recharge the car .

e).The car cannot be charged when the transmitter is lack of power， this happens when the 

    transmitter’s indicator light goes dim or be off, please replace the old batteries.

f ).Pay attention to the charging plug and interface when you charge the car

g).When not using the car for a long period，make sure the car has more than 50% power，

    and turn off the car, then remove the batteries from the transmitter.

h).There is a 1.2V（Ni-MH）rechargable battery inside the racing car，please charge the 

    car under  adults’s instruction.

i ).when removing the package , please make sure there is adult present.

j ).Keep this manual for future reference.

1.The racing car is using 1X1.2V 80MA  

   Ni-MH battery, transmitter is using 3X1.5V AA 

   non-rechargeable batteries.

2.Pay attentoin to the battery’s polarity when installing or

   replacing  the batteries.

3.Non-rechargeable battery cannot be charged.

4.Do not mix with old and new, or different types of batteries.

Please do not dispose this equipment as daily trash. Exhausted or damaged battery should be put into special designed 

container.This equipment is composed of electronic component and batteries, they belong to electronic trash, please be 

familiar with your local trash processing method.

5.Exhausted batteries must be taken out from the transmitter.

6.Avoid short-circuit.

7.Please remove and load the batteries according to the mark 

   shown on the battery compartment.

8.Chargeable battery can only be charged under the

   supervision of the adults.

9.Take out the battery from the transmitter when not using the 

    car for a long period.

2017(series)

Graph 3

Graph 6

Graph 7

①

②

Trim machine 

Graph10

Graph 9

Graph 4

Graph 5

Graph 2

Graph 8

Charging cover

Charging plug

Charging interface

Forward

Turn left

Turn right

Indicator

Reverse Charge LED

Battery recycling

Preparation:

Charge:

Operation:

CAUTION:

Instruction of the battery

      Warning: Changes or modifications to this unit not expressly approved by the party responsible 

for compliance could void the user’s authority to operate the equipment.

      NOTE: This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable 

protection against harmful interference in a residential installation. This equipment generates, uses 

and can radiate radio frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications.

      However, there is no guarantee that interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio or television reception, which can be determined 

by turning the equipment off and on, the user is encouraged to try to correct the interference by one 

or more of the

following measures:

     

Reorient or relocate the receiving antenna.

     

Increase the separation between the equipment and receiver.

     

Connect the equipment into an outlet on a circuit different from that to which

    the receiver is connected.

     

Consult the dealer or an experienced radio/TV technician for help

The device must not be co-located or operating in conjunction with any other antenna or transmitter.