GREAT WALL TOYS 2017B Manual Do Utilizador
1.Remove the color package and take out the plastic box.
Pull the button to the right as arrow 1 pointed, and get
the transmitter by the direction of arrow 2.(Graph 1)
Instruction manual
6+
ages
Graph 1
Name of product:1:67 mini racing car
Product features:
PLAYING TIME:6-10 minutes(equipped with large
capacity battery, the car can reach its best effect after
charing and discharging several times);
REMOTE CONTROL DISTANCE:6-20 metres;
GREAT PERFORMANCE:reliable frequency
selection and strong anti-interference ability.
2.Pull out the antenna as graph
2 shows.
3.Insert the antenna into the hole
at the top of the transmitter
and tighten it.(Graph3)
4.Open the battery cover,insert
3X1.5V AA battery with correct
polarity and replace the battery
cover.(Graph4)
5.Rip off the tape, pull out
the transparent cover.
(
Graph5)
6.Open the lock catch.(Graph6)
7.Drag the car according to the
direction ,and take out the car.
(
Graph7)
Open the charging cover and pull out the charging
plug,then insert the plug into the car’s charging
interface hole, the indicator light will be on,
around 7 minutes later, the indicator will be off ,
which means the car is fully charged, then pull out
the charging plug.(Graph 8)
1.Introduction of transmitter fuctions.(Graph 9)
2.Fully extend the antena when playing, turn on the power
switch of the racing car.
3.Press the transmitter and the indicator will be on which
means the racing car is ready to play. when pressing the
forward/backward button, the car will operate corresponding
action,meanwhile the car’s front/rear lamp will be on
according to the operation.If you want the car to turn left/right,
press left/right button and forward/backward button at the
same time.
4.At the bottom from the car’s forepart,there is a trim
machine which can correct the car to run in a straight line.
(Graph 10)
a).Do not touch the antenna during operation,or the remote control distance will be affected.
Breaking antenna needs adults to handle.
b).Due to the inertia and strong power of the car, it cannot stop immediately when running in
high speed.
c).If the car becomes apprently slow during operation, this may due to insufficient power,
please charge the racing car as this manual describes .
d).When the car is fully charged,please do not recharge the car .
e).The car cannot be charged when the transmitter is lack of power, this happens when the
transmitter’s indicator light goes dim or be off, please replace the old batteries.
f ).Pay attention to the charging plug and interface when you charge the car
g).When not using the car for a long period,make sure the car has more than 50% power,
and turn off the car, then remove the batteries from the transmitter.
h).There is a 1.2V(Ni-MH)rechargable battery inside the racing car,please charge the
car under adults’s instruction.
i ).when removing the package , please make sure there is adult present.
j ).Keep this manual for future reference.
1.The racing car is using 1X1.2V 80MA
Ni-MH battery, transmitter is using 3X1.5V AA
non-rechargeable batteries.
2.Pay attentoin to the battery’s polarity when installing or
replacing the batteries.
3.Non-rechargeable battery cannot be charged.
4.Do not mix with old and new, or different types of batteries.
Please do not dispose this equipment as daily trash. Exhausted or damaged battery should be put into special designed
container.This equipment is composed of electronic component and batteries, they belong to electronic trash, please be
familiar with your local trash processing method.
5.Exhausted batteries must be taken out from the transmitter.
6.Avoid short-circuit.
7.Please remove and load the batteries according to the mark
shown on the battery compartment.
8.Chargeable battery can only be charged under the
supervision of the adults.
9.Take out the battery from the transmitter when not using the
car for a long period.
2017(series)
Graph 3
Graph 6
Graph 7
①
②
Trim machine
Graph10
Graph 9
Graph 4
Graph 5
Graph 2
Graph 8
Charging cover
Charging plug
Charging interface
Forward
Turn left
Turn right
Indicator
Reverse Charge LED
Battery recycling
Preparation:
Charge:
Operation:
CAUTION:
Instruction of the battery
Warning: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
The device must not be co-located or operating in conjunction with any other antenna or transmitter.