Napco Security Technologies IBR 사용자 설명서
IBR-TOUCH & IBR-TOUCH-WL Quick Start Guide
1
© NAPCO 2018
WI2297LF
preliminary draft # .25
4/18
NAPCO iBridge
™
IBR-TOUCH &
IBR-TOUCH-WL Touchscreen Tablets
1
Unpack the touchscreen tablet
(
look carefully for the sup-
plied mounting hardware; the Power Adapter is only included with
the model IBR-TOUCH-WL
the model IBR-TOUCH-WL
)
Note: If using older ISEE Series Cameras, use your existing
ISEE-WAP (with its power adapter and CAT5 cable, shown).
ISEE-WAP (with its power adapter and CAT5 cable, shown).
IBR-TOUCH-WL
Touchscreen
Rear Case
2
Mount the touchscreen rear case to the wall using
screws appropriate for the mounting surface.
Power must be provided with the IBR-TOUCH-WL
using the 12VDC power adapter, observing polarity
(use the wire hole located in the center of the rear
case, shown below). The IBR-TOUCH connects
to the Gemini security system 4-wire bus.
screws appropriate for the mounting surface.
Power must be provided with the IBR-TOUCH-WL
using the 12VDC power adapter, observing polarity
(use the wire hole located in the center of the rear
case, shown below). The IBR-TOUCH connects
to the Gemini security system 4-wire bus.
3
Apply power to the control panel, the touchscreen
and the ISEE-WAP / IBR-ZREMOTE / StarLink
Connect radio. Upon power up, both touchscreens
will start within about 5 seconds (both can be manu-
ally powered by pressing and holding the small but-
ton on the right side for 10 seconds).
and the ISEE-WAP / IBR-ZREMOTE / StarLink
Connect radio. Upon power up, both touchscreens
will start within about 5 seconds (both can be manu-
ally powered by pressing and holding the small but-
ton on the right side for 10 seconds).
4
Upon power up, the Setup Wizard will automatically
start. Follow the sequence of images as shown in the
following steps, as necessary for the in-
stallation type.
start. Follow the sequence of images as shown in the
following steps, as necessary for the in-
stallation type.
If the Setup Wizard does
not automatically start, press and hold
the System Settings ("gear") icon, enter
your Dealer password, then tap Setup
Wizard.
the System Settings ("gear") icon, enter
your Dealer password, then tap Setup
Wizard.
"center hole" for
power or keypad bus
power or keypad bus
wires
CAT5 Cable
ISEE-WAP
Power Adapter
Power Adapter
Tap Yes and set the date, time and Time Zone (if
necessary). IMPORTANT: Outdated digital certifi-
cates will disallow connection to your iBridge or
StarLink Connect system, as well as inhibiting nec-
essary automatic firmware downloads.
cates will disallow connection to your iBridge or
StarLink Connect system, as well as inhibiting nec-
essary automatic firmware downloads.
5
Wait for the system diagnostics process to complete.
Functional components are marked with a check;
items not configured or not enabled are marked with
a "x". Selections are blank when the Setup Wizard is
run for the first time. Tap Configure to continue.
Functional components are marked with a check;
items not configured or not enabled are marked with
a "x". Selections are blank when the Setup Wizard is
run for the first time. Tap Configure to continue.
6
. .
System Settings
button
QUICK START GUIDE