ICOM 291400 사용자 설명서
63
9
CONNECTIONS AND MAINTENANCE
New2001
9
r Return the cables and screws to the original position.
• Be sure not upside down the flat cable.
CAUTION:
• When re-assembling the case and tightening the screws,
you must keep the specified torque (0.7±0.1 N.m). Oth-
erwise the transceiver may be damaged (torque too high)
or lose waterproof efficiency (torque too low).
erwise the transceiver may be damaged (torque too high)
or lose waterproof efficiency (torque too low).
• When uninstalling the optional unit, remove it vertically.
Wiggling the unit from side to side may damage the op-
tional unit's connector.
tional unit's connector.
■ HM-157/HM-162 installation
The optional HM-157/HM-162 can be connected to the trans-
ceiver directly, as well as via the supplied connection cable
for longer distance remote operation. The connector of the
connection cable can be installed into a cabinet, wall, etc., as
a built-in plug.
ceiver directly, as well as via the supplied connection cable
for longer distance remote operation. The connector of the
connection cable can be installed into a cabinet, wall, etc., as
a built-in plug.
For longer distance remote operation, the optional extension
cable, OPC-999/OPC-1541* (6 m; 20 ft/connecting between
transceiver and the connection cable), is available, and up to
two OPC-999/OPC-1541* can be added.
*OPC-999 : For the HM-157
cable, OPC-999/OPC-1541* (6 m; 20 ft/connecting between
transceiver and the connection cable), is available, and up to
two OPC-999/OPC-1541* can be added.
*OPC-999 : For the HM-157
OPC-1541 : For the HM-162
Do not connect the HM-162 to the OPC-999, and the HM-
157 to the OPC-1541.
Do not connect the HM-162 to the OPC-999, and the HM-
157 to the OPC-1541.
HM-157
HM-162
!IC-M504.qxd 05.12.28 11:30 AM Page 63 (1,1)