ICOM 297410 사용자 설명서
16
4
OTHER FUNCTIONS
0
4
Enabling the
■
intercom
When two headsets are connected to the transceiver, you
can use them as a voice-activated intercom.
can use them as a voice-activated intercom.
While holding down
q
[DUAL], rotate [VOL] to turn ON the
transceiver’s power.
• Configuration menu is displayed.
Rotate
w
[O-DIAL] to select “INCOM MODE.”
Rotate
e
[DIAL]
to set the intercom usable setting to ON.
Push
r
[RCL] to exit the Configuration menu and restart the
transceiver.
Hold down
Hold down
t
[DUAL] for two seconds to enable the intercom
function.
• “ICS” is displayed.
• You can set the headphone output level in the Settings menu.
• You can set the headphone output level in the Settings menu.
(p. 20)
• You can also set microphone 1 and microphone 2 audio input
levels in the Settings menu. (p. 20)
Opening the
■
squelch for test
This function manually opens the squelch for testing.
Push
q
[VOL] to turn ON the squelch test function.
• “RX” and “
TEST
” are displayed.
To turn the function OFF, push
w
[VOL] again.
• “RX” and “
TEST
” disappear.
Setting the
■
frequency step
You can select Frequency steps of 8.33 kHz or 25 kHz in the
menu mode.
menu mode.
Hold down
q
[RCL] for two seconds to enter the Settings
menu.
Rotate
Rotate
w
[O-DIAL] to select “FREQ. STEP.”
Rotate
e
[DIAL] to select the desired frequency steps
of 8.33 kHz or 25 kHz.
Push
Push
r
[RCL] to exit the Settings menu.
Using the
■
remote control
You can remotely control the frequency exchange switch, in-
tercom, and recall switch by connecting pins 1, 3, and 17* of
the D-Sub 25 pin connector on the rear panel to the switches
connected to the power ground.
Refer to “INSTALLATION GUIDE” for details.
tercom, and recall switch by connecting pins 1, 3, and 17* of
the D-Sub 25 pin connector on the rear panel to the switches
connected to the power ground.
Refer to “INSTALLATION GUIDE” for details.
• Turn the remote control in the Configuration menu ON. Refer to
page 25 for details.
* Connect pins L, 10, and 15 to the switches connected to the power
ground if you are using the optional MBA-3 connector.