Savari Inc. SAV-S50 사용자 설명서
6 Using the Command Line Interface (CLI)
This chapter describes the operations that you can perform using S-50 CLI commands. The S-50
comes pre-configured as described in the
Default Configuration (CLI)
section..
Caution: Only advanced users should use the instructions given below. Incorrect
modification of the following parameters may make the S-50 inoperable or inaccessible.
Note:
All configuration changes will only be applied once the device is power rebooted.
6.1 Network configuration
6.1.1 IP Address configuration
The IP address of the USB-Ethernet interface is factory set to 192.168.40.40. The IP address can
be changed if needed by the following command
1.
#cfg –a USB2ETH_IPADDR=a.b.c.d
2.
#cfg –c
3. Power cycle the OBU
The change is not persistent across FW upgrades.
6.2 Changing the Password
The password for the ‘root’ user can be changed using the following command.
1.
#passwd root
2. When prompted, provide the new password.
The change is not persistent across FW upgrades.
6.3 Transcore Application (TransApp)