Huntleigh Healthcare Limited Huntleigh Diagnostic Products Division SF1US 사용자 설명서

The receiver has two docking areas for the TOCO and US transducers, three 
sets of visual indicators (charging, battery level and transducer status) and the 
antenna for receiving transmissions from the US transducer when in use.  In 
addition, the rear panel includes the receiving antenna, RF-Channel selector, 
interface for connecting to the FM800 Encore Monitors, and line voltage input 
for power. 

The receiver and transducers have no buttons to operate. When identifi ed 
transducers are undocked, they are switched on automatically and the receiver 
indicates the status of batteries and the quality of the incoming RF-signal. When 
unidentifi ed transducers are undocked, they are switched off.

To start monitoring, the transducers are undocked from the receiver and applied 
to the patient.  It is recommended that the US transducer be applied to the 
patient fi rst.

The TOCO-Transducer transmits its signal to the US-transducer. The US 
transducer transmits both the US and TOCO signals to the receiver. 

The receiver does not have a mains switch. To turn on, connect the mains lead 
from the rear mains input to mains supply. Always leave the receiver connected 
to allow the transducers to be charged. If you want to switch off Freedom, dock 
both transducers fi rst, wait for charging indication, then disconnect the supply, 
wait 10 seconds. All units are now switched off. All modules are turned on when 
the receiver is powered again.  
When power is applied with an ultrasound transducer docked in the charging 
bay, it is automatically registered as belonging to this particular receiver 
(referred to as "pairing" or "paired").  This ensures that, where multiple wireless 
systems are being used in close proximity, there is no interference between 
systems. Successful pairing is indicated by the charge position LED switching 
on (not fl ashing).