Unique Broadband Systems Ltd. DRU1KW 사용자 설명서
Chapter
3
Installation
3.12 External Input Signal Interfaces
3.12.1 HB Cabinet
During the installation procedure, one external input signal connection must be made to the
HB cabinet:
HB cabinet:
S-Band Antenna (S-SAT)
Figure 3-31 HB Cabinet Cable Entrance
3.12.2 S-Band Antenna
The following steps should be performed to connect the S-Band antenna (HBE RF input) to
the DRU:
1. Run a cable from the S-Band antenna to the DRU.
2. If the cable does not already have a male N connector on it, install a male N
2. If the cable does not already have a male N connector on it, install a male N
connector on the end of the cable.
3. Attach and securely tighten the connector to the female N connector marked “S-
SAT”, which is located on the bottom-left side of the DRU – see Figure 3-31.
SX03-20000-01-M01 3-38