waterleakXsystems llc WLXS007 사용자 설명서
12
Electric Water Shutoff Valve for 1‐inch pipe
The Electric Water Shutoff Valve for 1‐inch pipe (WSV‐1”) must be installed downstream of the existing
facility water shutoff valve. When a leak occurs, the VCU signals the WSV‐1” to close and cut off the
water supply.
facility water shutoff valve. When a leak occurs, the VCU signals the WSV‐1” to close and cut off the
water supply.
Additional valves can be used as a pressure relief valve in the City Water Setup (see the Pairing and
Valve Installation section). It can also be purchased again if the original WSV‐1” that came with the
Basic System WLXS‐007 needs to be replaced.
Valve Installation section). It can also be purchased again if the original WSV‐1” that came with the
Basic System WLXS‐007 needs to be replaced.
We recommend that a licensed plumber install the valve to ensure that the installation complies with
local codes and regulations. Since the valve is low voltage, a licensed electrician is not required to
install this unit.
local codes and regulations. Since the valve is low voltage, a licensed electrician is not required to
install this unit.
Optional Components
All components are intended to be used with the WLXS‐007 waterleak
X
systems only. Any other use
will void its warranty.
Signal Repeater/Temperature Sensor
The Signal Repeater/Temperature Sensor (SRTS, or repeater) has two functions:
Extends the effective range of the system by repeating WDU signals to the CCU. This feature is
Extends the effective range of the system by repeating WDU signals to the CCU. This feature is
useful in larger homes or facilities that may have areas where radio signal reception is poor due to
steel or concrete dividers or other obstruction.
steel or concrete dividers or other obstruction.
Reports temperate extremes to the CCU. This feature is designed to alert you and assist in the
prevention of frozen pipes or detection of home or commercial HVAC systems failure.
This component must be plugged into a 120V outlet. It requires one (1) 9V lithium battery, to be
replaced once every 5 years, or once there is a low battery notification, whichever is sooner.
replaced once every 5 years, or once there is a low battery notification, whichever is sooner.
Important:
The first SRTS you install must be paired with the CCU, the VCU, and any WDU whose signal it is
The first SRTS you install must be paired with the CCU, the VCU, and any WDU whose signal it is
extending. This will be the primary repeater. It must be paired with the CCU as a sender and a
receiver, and with the VCU as a receiver only. It will receive signals from its paired WDUs and
transmit it to the CCU. Only the primary repeater must be paired with the CCU and VCU. Only the
primary SRTS can detect and report the high and low temperature alarm thresholds, which are set
using the CCU’s setup menu.
receiver, and with the VCU as a receiver only. It will receive signals from its paired WDUs and
transmit it to the CCU. Only the primary repeater must be paired with the CCU and VCU. Only the
primary SRTS can detect and report the high and low temperature alarm thresholds, which are set
using the CCU’s setup menu.