Tandberg Data Streamer SCSI DLT-V4 Internal Grey 7301 7088 00 사용자 설명서

Chapter 2  Installing the Tape Drive

Installing the Tabletop SCSI Tape Drive

DLT-V4 Product Manual

9

Figure 2  SCSI ID Selector 
Switch

2

In the final installation stage, you connect the SCSI and power cables to 

the tape drive.

To connect the SCSI and power cables to the tape drive, follow these 

steps:

Shut down the operating system and power down the server or 

workstation.

Power off all peripheral devices, such as printers and other SCSI 

devices.

Obtain a SCSI cable with an open 68-pin, high-density connector.

Connect one end of the SCSI cable to one of the connectors on the rear 

panel of the tape drive as shown in 

. Either SCSI connector 

works equally well. 

 does not show a terminator because 

none of the three tape drives in the illustration are at the end of the 

SCSI bus.

If the selected server or workstation does not already have an 

installed SCSI host adapter, you will need to install one. For 

more information on SCSI host adapter requirements, see 

 until you have completed steps 

. Failure to follow these instructions may result 

in damage to the tape drive or other devices.