Metra 99-7803G 사용자 설명서
99-7803G
Kit Assembly
Dash Disassembly
(Figure G)
(Figure A)
(Figure H)
(Detail)
Double DIN head unit provisions
1. Mount the radio brackets to the
1. Mount the radio brackets to the
radio trim panel with four of the
supplied #8 screws. (Figure A)
2. Slide the DDIN aftermarket radio
into the kit assembly and secure
with screws supplied with the
radio. (Figure A)
Continued on next page
3
7. Unsnap and remove upper panel
(including a/c vents) and remove
(3) Phillips screws behind the
panel. (Figure G)
Tip: You can use a hook tool to
grasp the panel inside of the vent
and pull toward the rear of the
vehicle. Be careful not to
scratch the panel.
8. Unclip and remove radio/climate
control assembly.
9. Cut and remove the center section
of the dash cavity. (Figure H)
Be sure to leave the outside clip
slots intact. (See detail)
Continue to kit assembly
Step 1.
Step 2.
Cut close without
cutting into clip slot
Remove shaded area