Netgear GS516TP GS516TP-100EUS 사용자 설명서
제품 코드
GS516TP-100EUS
Physical Description
12
GS516TP Gigabit PoE Smart Switch
The following figure illustrates the smart switch back panel.
Figure 2. Back panel
The back panel contains a power connector.
LED Designations
This section describes the designations of the LEDs found in the front panel of the smart
switch.
switch.
Port LEDs
The following table describes the RJ-45 port Link/ACT and PoE port status LED
designations.
designations.
Table
2-1. Port LEDs
LED
Designation
Link/ACT LED mode for copper
ports 1–16
ports 1–16
Link/ACT Mode LED:
•
•
Off. No link is established.
•
Solid green . A valid 1000 Mbps link is established.
•
Blinking green. The port is transmitting or receiving packets at
1000
1000
Mbps.
•
Solid yellow . A valid 10/100 Mbps link is established.
•
Blinking yellow . The port is transmitting or receiving packets
at
at
10/100
Mbps.
PoE Status LED for PoE ports
1–8
1–8
•
Off . No PoE powered device (PD) is connected.
•
Solid green . The PoE powered device (PD) is connected and the
port is supplying power successfully.
port is supplying power successfully.
•
Solid yellow . Indicates that one of the following failures resulted in
stopping power to that port:
- There is a short circuit on PoE power circuit.
- The PoE power demand exceeds power available.
- The PoE current exceeds PD’s classification.
- The supplied power is out of proper voltage band (44–57 VDC).
stopping power to that port:
- There is a short circuit on PoE power circuit.
- The PoE power demand exceeds power available.
- The PoE current exceeds PD’s classification.
- The supplied power is out of proper voltage band (44–57 VDC).
Power connector