Tandberg Data StorageLoader 2U LTO, 1 x 10 LTO-3 052102 사용자 설명서

A

PRIL

 2007

If the library has been successfully operating in the past, but is now 

experiencing problems, check the following:

✔

Control Mode. Make sure that the control mode is set correctly. 



Random mode (the default)—Only use this mode with an application 

that controls the library. 



Sequential mode—Only use this mode if you plan to operate without a 

backup application. In Sequential mode, the library automatically 

processes cartridges in sequential order without direction from an 

application. See 

 for information about setting Sequential mode. 

✔

Library functions. You can use the selections in the Maintenance menu to 

check specific library functions. See 

for instructions.

✔

Error messages. Check the list of error messages in 

 for corrective 

actions.

✔

Hardware operation. You can verify that the library hardware is operating 

using the following methods:



Use the Run System Demo mode under the library’s Maintenance menu 

to move cartridges from random cells in and out of the tape drive(s). See 

 for instructions.



Use the library’s Move menu to import or export cartridges, and to move 

specific cartridges into and out of the tape drive(s). See 

 for 

instructions.



Use LibTool to display the current inventory of cartridges, and to move 

cartridges in and out of the tape drive(s). Refer to the program’s online 

help for instructions on performing upgrades. You can download 

LibTool from

.

If the library reports an error during any of these tests, use the Remote 

Management Utility to obtain a diagnostic log from the library immediately 

after the error is reported (see 

). Alternatively, you can 

use FTP (via the Ethernet port) to obtain a diagnostic log from the library 

(see 

). Tandberg Data Corporation Technical Support can examine 

the log to determine the nature of the reported error. 

✔

Hardware Servo Error. If your library is reporting a hardware servo error, 

check the following:



Make sure the library is either installed in a rack or is resting on a hard, 

flat surface.



Make sure that there is nothing resting or pressing on the top of the 

library.