Netgear DUALBAND WLAN WNDAP360 N300 AP WNDAP360-PES 사용자 설명서

Basic Functioning

The Power/Test LED is first steady amber, then goes off, and then blinks green before 

turning steady green after about 45 seconds.

The Active LED is lit or blinks green when there is Ethernet traffic.

The LAN LED indicates the LAN speed: green for 1000 Mbps, amber for 100 Mbps, and 

no light for 10 Mbps.

The WLAN LED is lit or blinks green when the wireless LAN (WLAN) is ready.

If any of these conditions does not occur, see to the appropriate following section.

No LEDs Are Lit on the Wireless Access Point

It takes a few seconds for the power LED to light up. Wait a minute and check the Power LED 
status on the wireless access point. If the wireless access point has no power:

Make sure that the Ethernet cable between the wireless access point and the PoE switch 
is correctly connected at both ends.

Make sure that the power cord of the PoE switch is plugged into a working power outlet or 

power strip.

Make sure that your PoE switch is functioning normally.

Make sure that the power cord is connected to the wireless access point.

Make sure that the power adapter is connected to a functioning power outlet. If it is in a 

power strip, make sure that the power strip is turned on. If it is plugged directly into the 
wall, verify that it is not a switched outlet.

Make sure that you are using the correct NETGEAR power adapter that is supplied with 

your wireless access point.