Netgear DUALBAND WLAN WNDAP360 N300 AP WNDAP360-PES 사용자 설명서

The Active LED or the LAN LED Is Not Lit

There is a hardware connection problem.

Make sure that the cable connectors are securely plugged in at the wireless access point 
and the network device—hub, (PoE) switch, or router.

Make sure that the connected device is turned on.

Make sure that the correct cable is used. Use a standard Category 5 Ethernet patch 

cable. If the network device has Auto Uplink™ (MDI/MDIX) ports, you can use either a 
crossover cable or a normal patch cable.

The WLAN LED Does Not Light Up

The wireless access point’s antenna is not working.

If the WLAN LED remains off, either disconnect the cable to the PoE switch and then 

reconnect it again, or disconnect the adapter from its power source and then plug it in 
again.

Make sure that optional external antennas are tightly connected to the wireless access 

point. 

Contact NETGEAR technical support if the WLAN LED remains off.

You Cannot Access the Internet or the LAN from a 

Wireless-Capable Computer

There is a configuration problem.

You might not have restarted the computer with the wireless adapter to allow TCP/IP 

changes take effect. Restart the computer.

The computer with the wireless adapter might not have the correct TCP/IP settings to 

communicate with the network. Restart the computer and check that TCP/IP is set up 
correctly for that network. In Windows, the usual setting for Network Properties is to 
obtain an IP address automatically.

The wireless access point’s default values might not work with your network. Check the 

wireless access point’s default configuration against the configuration of other devices in 
your network.

Make sure that the SSID, network authentication, and data encryption settings of the 

computer with the wireless adapter are the same as those of the wireless access point.