AEG AR 4025 BT 400425 사용자 설명서

제품 코드

400425

ENGLISH

Recycling the packaging conserves raw

materials and reduces waste. Dispose of

any unwanted packaging materials in ac-

cordance with local regulations.

NOTE:

If possible keep the original packaging for the dura-

►

tion of the warranty period of the unit, in order that

you can repack the unit properly in the event of a

warranty claim.

Connection

WARNING:

Damage to property may occur when installing the

unit!

If possible have the unit installed by a qualified

►

specialist.

If you want to install the unit yourself, follow the

►

instructions on connection and installation for safe

and correct operation of the unit.

CAUTION:

Using the wrong connections may damage the unit.

When installing, use the ISO connections on the

►

unit. The vehicle-specific ISO adapter which may be

needed can be obtained from repair shops, specialist

retailers or in the relevant departments of depart-

ment stores.

Connections on the back of the unit

A ISO connection A (power supply)

B ISO connection B (speaker)

C Car fuse (5 A)

D Antenna connection

E Subwoofer connector cable

F Amplifier connector cable (front speaker)

F Amplifier connector cable (rear speaker)

Pinout of ISO connections

ISO connection A

1 not in use

2 Steering wheel control

3 not in use

4 Permanent positive (memory)

5 Control voltage for electronic/

motor antenna or amp

6 not in use

7 12 V (Positive under key)

8 Minus (Ground -)

1 3 5 7

2 4 6 8

ISO connection B

1 3 5 7

2 4 6 8

1 Speaker rear right +

2 Speaker rear right -

3 Speaker front right +

4 Speaker front right -

5 Speaker front left +

6 Speaker front left -

7 Speaker rear left +

8 Speaker rear left -

CAUTION:

Use speakers with an impedance of at least 4 Ohm.

►

The speaker wires must be floating.

►

NOTE:

Always use the cable for the front speakers to

►

connect the unit to two speakers.

Note that connection 4 must be connected to

►

permanent positive for auto preset.

In some car models the default pinout of connec-

►

tions [4] and [7] (ISO A) is swapped in the assembly

plant. If this is the case, auto preset may not func-

tion. To rectify the problem, connections 7 (positive

under key) and 4 (permanent positive) must be

swapped.

Antenna power connection A5 (ISO A)

CAUTION:

Potential damage to unit!

Never connect the antenna power connection to the

►

motor power cable for the antenna.

Max. allowed current: 100 mA.

►

The antenna power connection is available for a relay-

controlled antenna. The relay automatically extends

the antenna when the unit is switched on. The antenna

retracts again when the unit is switched off. This connec-

tion can also be used to control an external amplifier. To

connect this properly please refer to the amplifier

operating manual.