Reely QuadroCopter combi-board 450 + 650 208944 208944 데이터 시트

When the combiboard is installed in the QuadroCopter and the remote control was taught in, up
to four servos (channel 5 – 8) can be connected and operated by remote control. However, this
is only possible when the transmitter and the receiver provide these functions and the respective
receiver outputs are connected to the input plug of the composite signal converter (“X13”).
The following plug contacts are intended for the servo connection:
X5: Servo 1 (Receiver output/channel 5)
X6: Servo 2 (Receiver output/channel 6)
X7: Servo 3 (Receiver output/channel 7)
X8: Servo 4 (Receiver output/channel 8)

Please observe when connecting the servos that the impulse line (PPM) always has
to be connected to the upper pin of the three contact plugs!