Reely QuadroCopter combi-board 450 + 650 208944 208944 데이터 시트





The combiboard has eight LED outputs (“L1” to “L8”), and three digital inputs (“IN-1”, “IN-2”,
“IN-3”) and an external RC input (“PPM”) in addition to the composite signal converter.
Targeting of the LED outputs can be configured via 7 different modes.
The electronics either generate a fixed pattern on the outputs or the outputs are switched de-
pending on the input signals. The jumpers can be used to set modes, which can also be switched
into three states by a RC signal (channels 5, 6, 7, 8 or external). Thus, it becomes possible to
switch during flight.
Digital inputs:
The digital inputs switch the respective outputs when the respective mode was selected. A high
signal (+5 V) means that an output is switched on. The connected LED or the connected LED
strip is lit.
The three digital inputs are located at the interface connection “X10” and are assigned as fol-
lows:
IN-1 = Contact 6
IN-2 = Contact 5
IN-3 = Contact 16

Through the 3 digital inputs, different status displays or error messages of the
QuadroCopter can be displayed well visibly. The function of the output signals mainly
depend on the firmware used and can change during further development of the
QuadroCopter.

IN-1

IN-3

IN-2