ConiuGo 700100107 EasyGuard II 700100107 사용자 설명서
제품 코드
700100107
8
Revision 9.0
GSM Alarm & Telemetry systems
Digital inputs
The digital inputs are dedicated to simple sensors which support the module with a
contact indicating a logic level (high “1” or low “0”). Those sensors activate an inter-
nal switch (e.g. relay contact of a motion tracker) or are a swith itself (door and win-
dow contacts). The digital inputs have to be used by a potential free contact to
“ground". The status of the input then changes from “1" to “0". The contacts of
the switch resp. the relay will be sourced by the GSM Module input with 5 V, 15 mA.
The contacts should be able to switch a minimum load of 10 V, 50 mA.
The digital inputs are only suitable for potential free contacts.
You are not allowed to connect them with voltage.
Analog inputs
The analog inputs are dedicated for meassurements and are 10 Bit inputs. This
could be meassurement of different kinds (e.g. temperature, weight, air damp, etc.).
The modul reacts, depending on the kind of equipment on the sensor, on input cur-
rent or input voltage. The incoming signals are converted by the module into the
measures that correspond with the settings of the user. The signals that are meas-
ured permanently are supervised by the module regarding to the range that is de-
fined by the two valued “Min.” and “Max.”.
Integrated in the Module is an analog signal conditioning which consist of 4 current
inputs of 0/4 - 20 mA resp. 0 – 15 V in the basic series. All minus input poles are
connected internal to the “ground” of the module. The input voltage must not exceed
15 V DC.
The analogous inputs don't have any potential separation. Therefore it has to be
taken care on the correct grounding of all devices that are connected to the analo-
gous inputs of the module!
If you need analogous inputs that are conditioned to special sensors this should be
announced with your order. Any change in the signal conditioning later has to be
done by the manufacturer and the whole device has to be returned to the producer.
The will cause costs of 30,- € plus delivery cost,.
The inputs must be used strictly within the parameters of the
technical specification. Do not connect the GSM- module to any
other device that is capable of dangerous voltage or exceeds
the maximum input!