Texas Instruments DLP® LightCrafter™ Evaluation Module DLPLIGHTCRAFTER DLPLIGHTCRAFTER 데이터 시트
제품 코드
DLPLIGHTCRAFTER
Connecting to a PC
2. Turn on DLP LightCrafter using the On-Off switch. A new network using the RNDIS driver should
initialize.
•
The network interface on Windows systems may take a couple minutes to initialize. Please read
to speed up the initialization.
to speed up the initialization.
3. Open the DLP LightCrafter GUI.
4. Click the "Connect" button. See
.
•
The GUI connects to the IP address in the "Current IP Address" textbox from the "Connections"
tab. Please read
tab. Please read
steps 7 and 8 for more details.
•
After connecting, the GUI displays DLP LightCrafter's firmware versions. Select the correct tab,
according to the Display Mode, to update the GUI's tab settings to match the EVM's settings.
according to the Display Mode, to update the GUI's tab settings to match the EVM's settings.
Figure 2-1. DLP LightCrafter GUI Connect Button
5. Click the "Disconnect" button before disconnecting the USB cable between DLP LightCrafter and the
computer. See
•
The "Connect" button changes to the "Disconnect" button after a DLP LightCrafter connects.
•
Unplugging the USB cable before disconnecting can cause problems when trying to reconnect to
the DLP LightCrafter if the device has not been shutdown.
the DLP LightCrafter if the device has not been shutdown.
Figure 2-2. DLP LightCrafter GUI Disconnect Button
19
DLPU006C – January 2012 – Revised December 2013
Operating the DLP LightCrafter
Copyright © 2012–2013, Texas Instruments Incorporated