Texas Instruments UCD3138 Digital Power Factor Correction Pre-regulator Evaluation Module UCD3138PFCEVM-026 UCD3138PFCEVM-026 데이터 시트
제품 코드
UCD3138PFCEVM-026
Monitoring, Re-configuring and Re-tuning with Designer GUI
14.3 Configuration and Re-configuring with GUI
After click the tab of “Configure”, the corresponding page called “Configuration” is shown as in Figure 45.
The variables shown in the page are the existing configuration. Most of them are fixed and can only be
modified through firmware codes. One can designate which and how many variables can be re-configured
in this page through firmware codes change. With the single-phase PFC board, there are three variables
can be re-configured through this page without going through the firmware codes. As mentioned before,
modify these variables to a different value requires fully understanding the design to avoid possible
damage.
modified through firmware codes. One can designate which and how many variables can be re-configured
in this page through firmware codes change. With the single-phase PFC board, there are three variables
can be re-configured through this page without going through the firmware codes. As mentioned before,
modify these variables to a different value requires fully understanding the design to avoid possible
damage.
•
V
OUT
– PFC output bulk voltage
•
OV Fault – PFC output bulk voltage over voltage fault threshold
•
Freq – switching frequency in normal operation.
As mentioned earlier, the firmware version in use is shown in the page of “Configuration”. The firmware
version is called DEVICE_ID. When place the mouse curser on, the version indication is shown,
version is called DEVICE_ID. When place the mouse curser on, the version indication is shown,
UCD3100ISO1 | 0.0.8.0129 | 111209
The firmware version or Device_ID is divided by two vertical lines. UCD3100ISO1 is the IC device family
code. Between the two vertical lines, the show is the firmware recompilation indicator. The last six digits
are date of the last time the recompilation was made.
code. Between the two vertical lines, the show is the firmware recompilation indicator. The last six digits
are date of the last time the recompilation was made.
Figure 45. Page of Configuration
50
Digitally Controlled Single-Phase PFC Pre-Regulator
SLUU885B – March 2012 – Revised July 2012
Copyright © 2012, Texas Instruments Incorporated