Texas Instruments TSC2008EVM-PDK Evaluation Module TSC2008EVM-PDK TSC2008EVM-PDK 데이터 시트
제품 코드
TSC2008EVM-PDK
TAS1020B
USB 8052
microcontroller
USB
EVM Position 1
EVM Position 2
Control Interface
Audio Interface
TSC2008EVM
TSC2008
SPI, I2C
I2S, AC97
X+
X−
Y+
Y−
AUX
PENIRQ
SCLK
SS
MOS2
MT5C
Kit Operation
www.ti.com
Figure 1. TSC2008EVM-PDK Block Diagram
The USB-MODEVM interface board is intended to be used in USB mode, where control of the installed
EVM is accomplished using the onboard USB controller device. However, provision is made for driving all
the data buses (I
EVM is accomplished using the onboard USB controller device. However, provision is made for driving all
the data buses (I
2
C, SPI™, and I
2
S/AC97) externally. The source of these signals is controlled by SW2 on
the USB-MODEVM.
6.2
Quick Start
Before installing the TSC2008EVM board on top of the USB-MODEVM board, check SW2-1, SW2-2, and
SW2-3 on the USB-MODEVM board to ensure that at least one of these three is OFF
SW2-3 on the USB-MODEVM board to ensure that at least one of these three is OFF
Ensure that the TSC2008EVM is installed on the USB-MODEVM interface board. The TSC2008EVM
should be installed in the topmost position, using J11, J12, and J13 on the USB-MODEVM.
should be installed in the topmost position, using J11, J12, and J13 on the USB-MODEVM.
6
TSC2008EVM and TSC2008EVM-PDK User's Guide
SLAU248 – May 2008
Copyright © 2008, Texas Instruments Incorporated