Texas Instruments TSC2008EVM-PDK Evaluation Module TSC2008EVM-PDK TSC2008EVM-PDK 데이터 시트
제품 코드
TSC2008EVM-PDK
www.ti.com
Kit Operation
Place the CD-ROM into your personal computer (PC) CD-ROM drive. Locate the Setup program on the
disk, and run it. The Setup program installs the TSC2008 Evaluation software on your PC.
disk, and run it. The Setup program installs the TSC2008 Evaluation software on your PC.
Accept the license agreement, and continue the installation.
When the installation completes, click Finish on the TSC2008EVM installer window. You may be prompted
to restart your computer.
to restart your computer.
When installation is complete, attach a USB cable from your PC to the USB-MODEVM interface board. As
configured at the factory, the board is powered from the USB interface; so, the power indicator LEDs on
the USB-MODEVM should light. Once this occurs, launch the TSC2008 evaluation software on your PC. It
is suggested that users read the readme_install.txt file for up-to-date, step-by-step instructions.
configured at the factory, the board is powered from the USB interface; so, the power indicator LEDs on
the USB-MODEVM should light. Once this occurs, launch the TSC2008 evaluation software on your PC. It
is suggested that users read the readme_install.txt file for up-to-date, step-by-step instructions.
The software should automatically find the TSC2008EVM, and a screen similar to the one shown in
should appear.
Figure 2. Default Software Screen
In order to use the touch screen features, a user needs to connect a 4-wire resistive touch screen to J1 of
the TSC2008EVM, as described previously.
the TSC2008EVM, as described previously.
7
SLAU248 – May 2008
TSC2008EVM and TSC2008EVM-PDK User's Guide
Copyright © 2008, Texas Instruments Incorporated