Texas Instruments CDCM6208V2 Evaluation Module CDCM6208V2EVM CDCM6208V2EVM 데이터 시트
제품 코드
CDCM6208V2EVM
A Step by Step Guide on Updating the TUSB3210 Firmware for I2C communication on the CDCM6208 EVM
Figure 4. EVM SW4 Location
NOTE:
Once the board is powered up, turn SW4 back to the ON position to enable communication
between the EEPROM and the TUSB3210 chip. The board is now ready for programming.
Step 2 – Using the TI EEPROM Burner Software
To use the EEPROM Burner Software, simply boot up the program and appropriately fill out the pull down
menus. If the CDCM6208 EVM is recognized by the Burner software and driver, an option under the
“Select the USB Device:” should appear named “TI TUSB3210 EEPROMBurner”. This indicates the driver
has successfully connected to the TUSB3210 on the CDCM6208 EVM.
menus. If the CDCM6208 EVM is recognized by the Burner software and driver, an option under the
“Select the USB Device:” should appear named “TI TUSB3210 EEPROMBurner”. This indicates the driver
has successfully connected to the TUSB3210 on the CDCM6208 EVM.
The EVM features 512kbits of EEPROM, so select this option on the ”Select EEPROM Size:” drop down
menu. Finally, locate the location of the new firmware .BIN file. Use the Browse button near the “Select
EEPROM Image:” to locate the .BIN file location. A screenshot of the Burner software is provided in
menu. Finally, locate the location of the new firmware .BIN file. Use the Browse button near the “Select
EEPROM Image:” to locate the .BIN file location. A screenshot of the Burner software is provided in
12
CDCM6208 Evaluation Board
SCAU049A – May 2012 – Revised January 2013
Copyright © 2012–2013, Texas Instruments Incorporated