Texas Instruments TPS54162EVM Evaluation Module TPS54162EVM TPS54162EVM 데이터 시트

제품 코드
TPS54162EVM
다운로드
페이지 10
ENA
ENA
Disabled
Enabled
SR
SR
SR
SR
1 V/2.5 ns
1 V/4 ns
1 V/6 ns
1 V/1.2 ns
Delay
Delay
Delay
Delay
2.2 ms
47 ms
150 ms
200 ms
www.ti.com
Setup
Figure 2. Enable Jumper Settings
JP3 – Slew Rate is the jumper used to set the slew rate for the switch pin. The device slew rate should be
set between 15 ns and 200 ns. Slower slew rates can improve EMI performance, but they increase
switching losses. Jumper resistors allow the slew rate to be set to four set points. The user can set a
specific slew rate by changing one of the slew rate set resistors – R8, R9, or R10. Note that the slew rate
should be set to 1 V/1.2 ns if the EVM is configured for a 2-MHz switching frequency.
Figure 3. Slew Rate Settings
JP4 – Delay is the jumper used to set the delay time to assert the RESET pin low after the supply has
exceeded the programmed Vreg_RST voltage. The delay may be programmed in the range of 2.2 ms to
200 ms. Jumper capacitors allow the reset delay to be set to four set points. The user can set a specific
delay time by changing one of the delay capacitors – C13, C14, or C15.
Figure 4. Reset Delay Time Settings
2.2
Setup
The input voltage range for the converter is 3.6 V to 48 V. A load should be applied to the output terminal
for proper operation.
3
SLVU348 – October 2009
TPS54162EVM
Copyright © 2009, Texas Instruments Incorporated