Texas Instruments EZ430-CHRONOS-868 사용자 설명서
www.ti.com
eZ430-Chronos Sports Watch Software
3.2.2.9
Chronos-to-Chronos (C2C) Mode
This mode requires two eZ430-Chronos watches.
This mode allows the bidirectional control of two watches using SimpliciTI, the low-power RF network
protocol. Press "#" until "C2C" is shown. Press "DOWN" in both watches to initiate the connection. Wait
until both watches show the message "FOUND". After that the system is ready to go.
protocol. Press "#" until "C2C" is shown. Press "DOWN" in both watches to initiate the connection. Wait
until both watches show the message "FOUND". After that the system is ready to go.
1. "STAR" - Change menu (upper line)
2. "NUM" - Change menu (lower line)
3. "UP" - Change displayed Acc Axis (just for the acceleration menu)
2. "NUM" - Change menu (lower line)
3. "UP" - Change displayed Acc Axis (just for the acceleration menu)
To stop, press "DOWN" to close the connection.
Set function: None
NOTE:
The standard code for Chronos (out of the box) does not have the Chronos-to-Chronos
communication feature. The reason for that is the limited size in the flash (32KB). The code
for production has a special test function that ensures that everything is working properly
before shipping. Because this function is used only during production, a #DEFINE is
available to remove it and free the space necessary for the Chronos-to-Chronos
communication. This define is in project.h.
for production has a special test function that ensures that everything is working properly
before shipping. Because this function is used only during production, a #DEFINE is
available to remove it and free the space necessary for the Chronos-to-Chronos
communication. This define is in project.h.
29
SLAU292D – November 2009 – Revised March 2011
eZ430-Chronos Software
© 2009–2011, Texas Instruments Incorporated