Texas Instruments EZ430-CHRONOS-868 사용자 설명서
eZ430-Chronos Control Center PC Software
www.ti.com
3.3
eZ430-Chronos Control Center PC Software
The eZ430-Chronos Control Center software provides several features demonstrating the wireless
capabilities of the kit on Windows and Linux operating systems. Different RF protocol stacks are
automatically selected for use, depending on the function. Available features:
capabilities of the kit on Windows and Linux operating systems. Different RF protocol stacks are
automatically selected for use, depending on the function. Available features:
•
3D acceleration graph with PC mouse control
•
Wireless remote control / PowerPoint control
•
Time, date, and calibration data synchronization tool
•
Heart rate and speed simulator
•
Wireless firmware update
NOTE:
Connect the USB RF access point to the PC before launching the Control Center software.
For first time use, wait until Windows has finished the access point driver installation.
In case of problems on Windows PCs, check if the settings for the RF access point are
correct in the Windows Device Manager Start > Control Panel > System > Hardware >
Device Manager. The RF access point is listed under Ports (COM & LPT) as TI CC1111
Low-Power RF to USB CDC Serial Port. The port settings should be:
correct in the Windows Device Manager Start > Control Panel > System > Hardware >
Device Manager. The RF access point is listed under Ports (COM & LPT) as TI CC1111
Low-Power RF to USB CDC Serial Port. The port settings should be:
•
Baud Rate: 115200
•
Data bits: 8
•
Parity: None
•
Stop bits: 1
•
Flow control: None
In case of problems on Linux PCs, ensure that the correct tty setting is specified. Check /dev
for the new tty device after plugging in the RF access point. If the RF access point is
assigned to a device other than ttyACM0, either remove the serial device that occupies this
slot (for example, a modem), or change the script file variable "com" in
eZ430-Chronos_CC_1_2.tcl located in /home/<user name>/Texas
Instruments/eZ430-Chronos/Control Center/eZ430-Chronos Control Center.
for the new tty device after plugging in the RF access point. If the RF access point is
assigned to a device other than ttyACM0, either remove the serial device that occupies this
slot (for example, a modem), or change the script file variable "com" in
eZ430-Chronos_CC_1_2.tcl located in /home/<user name>/Texas
Instruments/eZ430-Chronos/Control Center/eZ430-Chronos Control Center.
To launch the Control Center software on a Windows PC, shortcuts are available on the Desktop and in
the Start Menu under Programs > Texas Instruments > eZ430-Chronos > eZ430-Chronos Control Center.
the Start Menu under Programs > Texas Instruments > eZ430-Chronos > eZ430-Chronos Control Center.
To launch the Control Center software on a Linux PC, browse to /home/<user name>/Texas
Instruments/eZ430-Chronos/Control Center/eZ430-Chronos Control Center and run
eZ430-Chronos_CC_1_2.tcl.
Instruments/eZ430-Chronos/Control Center/eZ430-Chronos Control Center and run
eZ430-Chronos_CC_1_2.tcl.
The different features are grouped onto tabs of the Control Center window. The tabs also indicate which
radio protocol is used.
radio protocol is used.
30
eZ430-Chronos Software
SLAU292D – November 2009 – Revised March 2011
© 2009–2011, Texas Instruments Incorporated